Drilling Into Concrete Wall Condo

If you have to drill into a concrete living room you need to use a hammer drill fitted with tungsten carbide masonry bits.

Drilling into concrete wall condo.

If necessary tap. However drilling concrete is much easier with a hammer drill or a rotary hammer for large jobs. Buy or rent a good hammer drill. If you re just drilling one or two holes for a small project a regular drill is fine.

Just to give you an idea drilling a 1 inch hole in a 4 inch concrete slab using a hammer drill would probably take around 60 seconds. Match the correct anchor size to that of the concrete screw. Step 1 mark the position of the holes as always the accurate marking of the holes is important. It would take a shorter time using a rotary hammer approximately 20 seconds.

These tools fracture the concrete through rapid hammering then drill to scoop out the broken material. Remove any concrete dust then press the anchor into the hole until it is flush with the surface. While holding the drill perpendicular to the ceiling surface press the trigger and begin to drill into the concrete using the hammer action option on the drill. Next you are going to need a good concrete drill bit.

You will definitely need a drill bit meant for concrete. It s not hard but drilling concrete does take a lot longer than drilling through wood or metal. One rule of thumb is to be especially careful when drilling into any walls that connect to your bathroom or kitchen basically any wall that s likely to have pipes. Usually diamond or carbon coated drill bits are what you will need.

The hole should be slightly smaller than the maximum width of the. Then you ll need to insert concrete anchors and then your fasteners screws. A regular steel bit is not hard enough to make a clean hole and will just over heat and break if you even try. Expand the drill hole to accommodate the anchor.

If you do hit a pipe williams. Heavy shelves or cabinets will require screwing to a stud which you are referring to as a beam. If your wall covering is sandy plaster then you would attach light shelves and pictures by pre drilling holes with a masonry bit and using expanding anchors or toggle bolts.